Model Number

Minco F2

MINCO F2 controller is the new control device of the engine operating parameters comprehensive monitor and protection , It is not only applicable to various models and powers of the diesel engine infrastructure, upgrade the engine digital display, automatic protection features such as technical performance, but also for assembly automation genset provides a cheap and practical solution.

F2 controller also widely used in fire pump, air compressor, industrial engine etc. automation equipment, such as ECU.

I. Characters
1. LED display: Rotate speed/frequency, Coolant temp., oil pressure, 

    battery voltage, running time, fuel level/oil temp.

2. Manual or remote start, auto start, auto protection, ATS control;

3. Fault protection and indicator: emergency stop, over speed, low battery 

    voltage, high water temp., low oil pressure, over crank,lose speed signal,

    input define.

4. Water temp., oil pressure simulate or switch sensor currency, speed can

    get from sensor or frequency.

5. 50HZ, 60HZ currency.

6. Smart out look, damp proof, shockproof.

7. Electronic governor and acc/dec adjustment currency, Acc and Dec in 

    right position input monitor, also suit to native genset.

8. Quick connect or disconnect the terminal.

II. Appearance Features

1.  Dimension Front panel (L×WxD 96x96x9mm

                Back panel (LxWxD)  84x84x50mm

     Mounting hole (L×W85x85mm   

2.  Power Supply DC8-40 V,<300 mA

3.  Working environment -25~70,relative humidity  <95%

MINCO F2 well replace the168/17,170/180,501/520 controller, the main advantage is:

1) Add display function, included rotate speed/frequency, oil pressure,

    water temp., battery voltage, running time,fuel level/oil temp. 

    Etc.,Savings meters and labor costs.

2) Water temp. sensor can be analog or switch input,genset rotate can be 

    from frequency or pick up by speed sensor,electronic governor or

    ACC/DEC control compatible.It's reduced the changing sensor and well

    adapted the engine.

3) Key-press setting function, all main parameter can be setting by front 

    Panel.